CCI - 710 Epoxy 100% Solids, Two-Component and Prime

• Description

• Benefits

• Areas of Use

• Technical Data

• Special Notes

• Availability

• Surface Preparation

• Application

DESCRIPTION

CCI-710 is a high grade two component, 100% solids, flexible epoxy coating with excellent blush resistant and chemical protection along with exceptional UV stability while providing a high-gloss. CCI-710 has good chemical and superior resistance to wear from abrasion.

BENEFITS... back to top

• Nonporous: Prevents chemical migration to the substrate, which can cause disbanding and environmental contamination.

• 100% Solids: Low odor makes it ideal for use in Pharmaceutical and Food & Beverage facilities.

• Attractive: High gloss finish with excellent gloss and color retention.

• Chemical Resistant: Provides resistance to many common industrial chemicals. Consult your distributor or Chem-Coat for recommendations.

• Hygienic: Sealed surface allows easier cleaning.

AREAS OF USE ... back to top

• Pharmaceutical Plants

• Wastewater Treatment

• Food and Beverage Plants

• Loading Docks

• Commercial Kitchens Mechanical Rooms

• Dairies Production Lines

TECHNICAL DATA... back to top

SPECIAL NOTES... back to top

• Adhesion
  (ASTM D-4541) >250 psi (concrete fails)

• Flexural Strength
  (ASTM D-790) 6,200 psi

• Hardness
  (ASTM D-2240) 84 Shore D

AVAILABILITY... back to top

CCI-700 Primer is available in 55 gallon drums and 5 gallon pails. CCI-700 Primer is also available in totes, bulk containers and bulk shipments. Please call Chem-Coat Industries directly to discuss your customized packaging requirements.

SURFACE PREPARATION... back to top

Old Concrete must be clean, sound, dry and free of all foreign materials such as oils, grease, loose paint, dust and laitance. This may be accomplished by sand blasting or scarifying, followed by an air blast to remove dust and debris from the application area. New concrete should be acid etched, rinsed thoroughly and allowed to dry

APPLICATION... back to top

CCI-710 provides a smooth, high-gloss finish and exceptional UV stability. This product should be applied in two coats; the first coat being 5-6 mils and the second being 10-12 mils. Mix Entire Part A and Part B prior to adding the hardener. Once activated, the material should be poured on to the substrate and spread at desired coverage using a squeegee. A 3/8” non-shedding roller should be used to evenly distribute and finish the coating. First coat approximately 225 sq. ft., second coat 175 sq. ft. per gallon. The second coat, if required, should be applied when the first coat is tack-free, which is normally 6-8 hours.

MIXING AND APPLICATION

• Stir each component separately.

• Clear: Mix 2 volumes of part A with 1 volume of part B.

• Pigmented: Mix 1 volume of part A with 1 volume of part B.

Mix thoroughly, being sure to scrape the sides and bottom, with a strong mixing stick or slow-speed drill equipped with a paint propeller.

Do not mix more than can be applied in 15-20 minutes (Pot Life).

As a coating, apply mixed material by brush or roller.

For best results, two coats should be applied. Allow the first coat to cure overnight. Apply the second coat within 24 hours. If more time than 24 hours has elapsed, a light sanding of the first coat is required. CCI-710 can be placed as thick as desired on horizontal surfaces without affecting the cure.

When slip proofing is required, broadcast sand, emery or carborundum into the first coat while still tacky. Apply the second coat to seal.