CCI - 4000 Water-Based Water Repellent

BENEFITS... back to top

• Clear

• Long Lasting

• VOC Compliant

• Deep Penetrating

• Proven Quality

• Helps Prevent Water Damage

• Easy to Apply

SUBSTRATES... back to top

• Concrete

• Brick

• Stucco

• Clay

• Tile

• Masonry

• Concrete

• Stone

HEALTH AND SAFETY ... back to top

Do not take internally. Keep out of the reach of children. Avoid contact with skin and eyes. Do not transfer to another container. Do not mix with other chemicals. Use only with adequate ventilation, open all doors and windows. If you should experience any discomfort such as eyes watering, difficulty in breathing, headaches or dizziness, stop using the product and get fresh air. First Aid: If swallowed get medical attention immediately. In case of eye contact, flush eyes with water for 15 minutes and get medical attention. If difficulty in breathing occurs move to fresh air. If in a few minutes breathing is not normal get medical attention immediately. If products get on skin wash with soap and water. Wear protective gear for eyes and skin.

AVAILABILITY... back to top

1- Gallon Units        5- Gallon Units        55- Gallon Drums

APPLICATION... back to top

1. Before beginning work do a small test in an inconspicuous area to assure compatibility of all products and approval. Each job and surface is different so it is very important to test material for each surface to be sealed.
    

2. Spread rate will depend on the surface and will vary depending on the porosity of the substrate:

   • Brick 100-200 sq. ft./gal.

   • Concrete Block 65-75 sq. ft./gal.

   • Stone 100-150 sq. ft./gal.

   • Concrete 175-200 sq. ft./gal.
      

3. Product is ready to use. Do Not Thin.
    

4. All contaminates must be removed from the surface, such as dust, oil, and any other material that could block the penetration of CCI-4000 into the surfaces.
    

5. The surface should be completely dry due to the fact that CCI-4000 reacts to water.
    

6. Apply by brush, dipping, or sprayer (pump up garden unit is recommended).
    

7. Tools can be cleaned with water. If material is allowed to dry, paint thinner should be used to clean tools.
    

8. Do Not Apply CCI-4000 if temperature is below 45 Degrees F.
    

9. CCI-4000 will repel paint.
    

10. Dry time will depend on the temperature and substrate. When surface is dry it may be used but total cure is about 48-72 hours.

IMPORTANT

Chem-Coat Industries Inc. shall not be liable for cost of labor direct or incidental or any consequential damages. The information contained herein is for illustration purposes only and, to the best of our knowledge, is accurate and reliable. Chem-Coat Industries Inc. under any circumstance makes no guarantee of result or assumes any obligation or liability in connection with the use of this information and product. It is recommended that a test area be done first to determine suitability and if the information is valid in a particular circumstance. Responsibility remains with the owner, contractor and/or specifier, for the design, application, and proper installation of the products. User/Owner/Specifier will determine suitability of products for specific applications and assume all responsibilities in connection therein.

It is important to remember when the beading stops the surface is still sealed. When the surface starts to darken with water or liquid it it time to reapply more product. CCI-4000 will help aid in slowing down water damage but it is important to make sure proper care and precautions are followed to assure protection, care, and long life of products being protected.